#LOXONE EIB TASTER UPDATE#
#LOXONE EIB TASTER PC#

My wife and kids just can't wait for me to resolve the problems. Does anybody have a knowledgeable KNX guru that I can hire to get me over the finish line? Ordinarily, I would struggle until the problem was located.

#LOXONE EIB TASTER PC#

EtS5 is set up on a Windows PC with remote desktop connection. I have tried to find someone in the United States but KNX is really unknown here. I really need professional help (the KNX type). We have lived in our house for almost 9 months and we still can't turn on our lights. I know that there are small mistakes being made but without the experience, I don't know where. I terribly frustrated and feel a bit overwhelmed. I have just accepted that the miniserver won't connect until ETS5 is properly configured. If I have the POE IP interface, do I still need a separate power supply? Also, the KNX light on the IP interface does not illuminate.Īs far as the miniserver, I have not been able to connect to it through ETS5.

It is POE and I have it connected to a Ubiquiti POE switch. Unfortunately, no.įrom the miniserver, KNX enters the IP interface by a twisted pair of Cat 6. Recently, in my never ending pursuit of KNX functionality, I purchased a N000401 from EIBMarkt I thought that maybe with an IP interface, my problems would be resolved. My miniserver is v1 and it is located in our lower level.

#LOXONE EIB TASTER UPDATE#

I will provide an update on my hardware as requested. I didn't receive notification that anyone had responded to my posts. Checkout their KNX Powersupplys ( ) and IP Interfaces IP routers ( ) So for a serious KNX installation i would suggest to buy a additional KNX IP Interface / Router.Ī KNX brand where you get a good bang for the buck is for example MDT. A normal power supply will not work as this would not allow to put data on the same physical wire together with the power.Īnd please note, that depending on the devices, not all devices can be programmed by the miniserver (as programming interface) as the miniserver seems not to fully comply with the KNX standard. As Christian already mentioned, we would need more informations.įor getting the KNX Bus up and running, you will need a 'KNX Power Supply' beside the Miniserver on the bus.This (special) KNX Power Supplys creates the electrical KNX Bus environment where all KNX devices (like actors, sensors e.g.

Loxone eib taster